| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Oil viscosity https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=17&t=55276 |
Page 1 of 1 |
| Author: | Scallywag 110 [ Thu Jul 31, 2014 9:32 am ] |
| Post subject: | Oil viscosity |
I'm running Royal Purple 5w30. Concerned that it might be too light for our Louisiana temps. |
|
| Author: | msm8281 [ Thu Jul 31, 2014 9:36 am ] |
| Post subject: | Re: Oil viscosity |
People had problems in the past with modded motors running royal purple. It's hard to say it was from the oil or not though Amsoil z rod is what a lot of people are using with success on nodded motors. So if u want a high performance oil I would suggest Amsoil. |
|
| Author: | rob_E [ Thu Jul 31, 2014 12:09 pm ] |
| Post subject: | Re: Oil viscosity |
not sure if its good or bad but I run shell rotella SAE 30 in all my air cooled engines; mud motor, lawn mower, and my generator. |
|
| Author: | baron von [ Thu Jul 31, 2014 1:17 pm ] |
| Post subject: | Re: Oil viscosity |
the Scamsoil guy talked me into a case of this - it seems not to turn black as soon other oil in my air cooled engines |
|
| Author: | BKScripto [ Thu Jul 31, 2014 3:27 pm ] |
| Post subject: | Re: Oil viscosity |
I use AMSOIL in everything. Just dumped the oil in my Civic after 15k and it wasn't even black. |
|
| Author: | BKScripto [ Thu Jul 31, 2014 3:28 pm ] |
| Post subject: | Oil viscosity |
OP, no harm in bumping up to 10w-30 during the hot months. |
|
| Author: | krogers [ Tue Aug 05, 2014 9:23 am ] |
| Post subject: | Re: Oil viscosity |
I used to run that expensive shit, now I run 10w30 rotella. |
|
| Author: | Will [ Tue Aug 05, 2014 9:26 am ] |
| Post subject: | Re: Oil viscosity |
| Author: | baron von [ Tue Aug 05, 2014 9:29 am ] |
| Post subject: | Re: Oil viscosity |
It’s 2 ½ quarts Mcscrooge – not going to break anyone’s bank roll |
|
| Author: | Will [ Tue Aug 05, 2014 9:38 am ] |
| Post subject: | Re: Oil viscosity |
$27.50 versus $10.00 per oil change, that leaves enough for a 12 pack and a bag of beef jerky. |
|
| Author: | krogers [ Tue Aug 05, 2014 9:46 am ] |
| Post subject: | Re: Oil viscosity |
| Author: | baron von [ Tue Aug 05, 2014 9:49 am ] |
| Post subject: | Re: Oil viscosity |
| Author: | MarshJB [ Tue Aug 05, 2014 9:50 am ] |
| Post subject: | Re: Oil viscosity |
Does anyone use the Valvoline VR1 conventional? I've been using it for 120 hours now. |
|
| Author: | baron von [ Tue Aug 05, 2014 9:51 am ] |
| Post subject: | Re: Oil viscosity |
| Author: | DmaxHunter [ Tue Aug 05, 2014 9:52 am ] |
| Post subject: | Re: Oil viscosity |
I've been running the amsoil for briggs, good stuff |
|
| Author: | krogers [ Tue Aug 05, 2014 9:54 am ] |
| Post subject: | Re: Oil viscosity |
| Author: | ajverret [ Mon Aug 11, 2014 2:36 am ] |
| Post subject: | Re: Oil viscosity |
I've been using Castrol edge full synthetic 10w 30 and it's holding up fine |
|
| Author: | GeeLeDouche [ Tue Aug 12, 2014 9:25 am ] |
| Post subject: | Re: Oil viscosity |
Rotella user here. |
|
| Author: | BayouBuster [ Tue Aug 12, 2014 10:45 am ] |
| Post subject: | Re: Oil viscosity |
Rotella FTW!! |
|
| Author: | mudxxed [ Tue Aug 12, 2014 10:47 am ] |
| Post subject: | Re: Oil viscosity |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|