| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Fabrication work near Shreveport? https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=10627 |
Page 1 of 1 |
| Author: | dead duk [ Fri Jul 02, 2010 3:55 pm ] |
| Post subject: | Fabrication work near Shreveport? |
I would like to find someone to do a couple of projects to my boat. I have already cut out the middle bench on my boat and want to beef up the bracing where the seat was. I have also cut the middle portion of the back bench out and turned it into pods. I need someone to do the welding on those as well. Any opinions on where to take my boat? I understand there may be someone in Marshall that can do custom work. Thanks for the advice. |
|
| Author: | cb5331 [ Fri Jul 02, 2010 5:02 pm ] |
| Post subject: | Re: Fabrication work near Shreveport? |
I'm not sure if Andy in marshall is back up and running yet. You may try to pm willet. He used to work with him and is doing some work on his own now out of Tyler. He should know if Andy is working yet, or he may be able to help you out himself. There is a few other fellas in that neck of the woods that may have someone to recommend also. |
|
| Author: | POKER1 [ Fri Jul 02, 2010 8:50 pm ] |
| Post subject: | Re: Fabrication work near Shreveport? |
I checked all over Sport & Bossier when I needed some work in the past. At the time the only one I found was Little Joes up towards Benton. But the economy was much better then also. I just get with Willett or if Andy is on his feet again he may be able to help you. Both are good folks and do a good job at a very reasonable price. |
|
| Author: | cb5331 [ Fri Jul 02, 2010 10:26 pm ] |
| Post subject: | Re: Fabrication work near Shreveport? |
| Author: | dead duk [ Sat Jul 03, 2010 11:05 am ] |
| Post subject: | Re: Fabrication work near Shreveport? |
Thanks for the advice. I will track them down. |
|
| Author: | got duck [ Mon Jul 05, 2010 11:21 pm ] |
| Post subject: | Re: Fabrication work near Shreveport? |
This is Andy. Give me a call. 903-578-0108 |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|