MudmotorTalk.com
https://www.mudmotortalk.com/mmt_v2/

1751SWF4 Excel with 23 LA Mud Buddy
https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=14367
Page 1 of 1

Author:  Bayou Meto [ Tue Dec 07, 2010 2:59 pm ]
Post subject:  1751SWF4 Excel with 23 LA Mud Buddy

Would a 1751SWF4 Excel with 23 LA Spec. Mud Buddy be a good Match
Load - 2 men (400lbs), 1 70lb Lab and Normal Duck Hunting Stuff
About what would the speed be-
Could it cut a rut in the mud
Hunt Areas with a 25 hp restriction

Author:  Chico80x [ Tue Dec 07, 2010 7:27 pm ]
Post subject:  Re: 1751SWF4 Excel with 23 LA Mud Buddy

That's a very small motor for the size boat you have and I'm guessing you will do between 15 and 18 mph with it, maybe. My boats almost identical in size to yours with a MB 5500 and it will run about 27 mph with the same load you are talking about so that should give you an idea what to expect with a 23hp.

Author:  Barroll [ Wed Dec 08, 2010 11:37 am ]
Post subject:  Re: 1751SWF4 Excel with 23 LA Mud Buddy

That excel is a very heavy boat and a 23 is not enough hp for that. If i was you and were limited to 25 and under i would get a 1544 gatortrax with the 23mb. I think you will be disappointed with a small motor on a big boat. Besides, with only 2 guys you shouldnt need a 1751

Author:  keestan31 [ Wed Dec 08, 2010 11:59 am ]
Post subject:  Re: 1751SWF4 Excel with 23 LA Mud Buddy

Like they said I think you will be underpowered for that boat

Author:  autogateman [ Wed Dec 08, 2010 12:01 pm ]
Post subject:  Re: 1751SWF4 Excel with 23 LA Mud Buddy

your name is too close to Bayou MetRo. jus sayin :D

Author:  UNCLE-J [ Wed Dec 08, 2010 12:06 pm ]
Post subject:  Re: 1751SWF4 Excel with 23 LA Mud Buddy


Author:  Ducaholic [ Thu Dec 09, 2010 12:55 pm ]
Post subject:  Re: 1751SWF4 Excel with 23 LA Mud Buddy

Keep in mind that the 17X51 Excel is not actually 51" wide as in the case of a hard chine boat...more like about 44" of actual plaining surface on the water...which means it takes even more HP to get it moving and on plain...

With a 23HP boat you can go with any type chine...the more square the better...16X48 or 16X44 sounds about right...16X38 GT Rogue would also be a good choice...

I had a 25HP MB surface drive and with two guys the 16X44 Alweld boat I was running did real well...any more than that and it was tough to get on plain...

Author:  b_coonass [ Thu Dec 09, 2010 1:17 pm ]
Post subject:  Re: 1751SWF4 Excel with 23 LA Mud Buddy

[quote="UNCLE-J"]You need like a 16x48 TOPS...

X2!

Author:  Bayou Meto [ Fri Dec 10, 2010 12:08 pm ]
Post subject:  Re: 1751SWF4 Excel with 23 LA Mud Buddy

Thank Yall for the Reply
I am going to have a 35hp MB put on it
Maybe i can Camo it up and still get it on the Refuge (25hp restriction)
Boat should be ready next week (Dec 15)
Can't hardly wait - It been 4 weeks since order was placed.
Thought I was going to get before Thankgiving - delay, delay !! delay
Were still killin ducks- Fields and Lake
But Its tough going on the lake - 2" to 18" of water (2-1/2 mile long old Arkansas River Oxbow) filled with Lily pads, Cypress, and Duck Weed, the ducks are lovin it.
Green Heads to Yall
Thanks Again

Author:  Phathead [ Fri Dec 10, 2010 1:06 pm ]
Post subject:  Re: 1751SWF4 Excel with 23 LA Mud Buddy

Go ahead camo it up and make it real pretty----but that ain't gonna stop Mr. Green Jeans from writing you a nice little ticket. You will stick out like a sore thumb running that mudmotor at Bayou Meto or any of the other hp restricted WMA's here in AR and you will be the 1st one checked and ticketed. Buy yourself a good 25 hp motor (outboard or sd) and play by the rules, or atleast don't be a dumbass and come on here and announce your gonna break the law.

Author:  Bayou Meto [ Fri Dec 10, 2010 2:00 pm ]
Post subject:  Re: 1751SWF4 Excel with 23 LA Mud Buddy

That is the reponse I hope I would get -
Never Hunted Bayou Meto for Ducks and Never will
fight that public nightmare
We do permit hunts for deer, squirrel hunt and thats about it
Hunt our own land during duck season
Oh- my Uncle Wildlife Officer hunts with us ever chance he gets
By the way more than one of your members made the suggestion
of camo the motor and motor on
Was it you
Thanks Again

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/