| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| short PRO DRIVE to long?? https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=1654 |
Page 1 of 1 |
| Author: | DennisB. [ Sat Apr 18, 2009 6:50 am ] |
| Post subject: | short PRO DRIVE to long?? |
How hard is it to make this motor a long shaft??? I know there is some welding involved?? |
|
| Author: | texman034 [ Sat Apr 18, 2009 5:48 pm ] |
| Post subject: | Re: short PRO DRIVE to long?? |
I just had my 32 converted a few weeks ago. It cost about $300 out the door. I had it done at the PD shop, and they had it knocked out in a couple of hours. |
|
| Author: | idabilly [ Sun Apr 19, 2009 9:53 pm ] |
| Post subject: | Re: short PRO DRIVE to long?? |
Not the hardest project in the world. Just did it last week. Two guys doing it for the first time took maybe four hours, and that was really taking our time. You do have to weld aluminum on the outer housing. If Texman was saying that you could get out the door with parts and labor included for $300 and you are close enough to carry your motor over to them you should jump on that deal. |
|
| Author: | oneneo3 [ Mon Apr 20, 2009 1:20 pm ] |
| Post subject: | Re: short PRO DRIVE to long?? |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|