| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| 16x54 Express / Prodrive https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=25183 |
Page 1 of 1 |
| Author: | lparrish [ Fri Dec 23, 2011 6:50 pm ] |
| Post subject: | 16x54 Express / Prodrive |
The 50 Yamaha on my 16X54 Express is shot. Im thinking about putting a Prodrive on the boat. Anyone have any experience with this combination. The boat has a 21" transom. |
|
| Author: | T-Bubba [ Fri Dec 23, 2011 6:58 pm ] |
| Post subject: | Re: 16x54 Express / Prodrive |
roll with it |
|
| Author: | Woodiebuster [ Fri Dec 23, 2011 10:03 pm ] |
| Post subject: | Re: 16x54 Express / Prodrive |
It'll work, just not as good as the right hull for da motor will. Welcome to MMT, Where ya from? |
|
| Author: | mcculloughp [ Sat Dec 24, 2011 9:03 am ] |
| Post subject: | Re: 16x54 Express / Prodrive |
This is what I'm running. Works fine with a light load (28 mph), but falls off quickly as you load her up. |
|
| Author: | pooldoo73 [ Sat Dec 24, 2011 9:13 am ] |
| Post subject: | Re: 16x54 Express / Prodrive |
PD will work fine. Later on u can upgrade your boat if u find that u want a bigger, different boat. |
|
| Author: | crittergitter [ Sat Dec 24, 2011 10:00 am ] |
| Post subject: | Re: 16x54 Express / Prodrive |
I have this exact same setup i built a deck up front moved fule tanks to the front myself at 250lbs one other at 215lbs we ran 24 steady by myself i ran 25.4 this is a stock 36pd |
|
| Author: | lparrish [ Sun Dec 25, 2011 8:27 am ] |
| Post subject: | Re: 16x54 Express / Prodrive |
Thanks for the information. I was worried about the rear bench seat getting in the way while driving. |
|
| Author: | OwenDickeson [ Sun Dec 25, 2011 9:21 am ] |
| Post subject: | 16x54 Express / Prodrive |
It might if you hit a stump, so watch your fingers |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|