| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| replacing PD hyrdo line https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=3365 |
Page 1 of 1 |
| Author: | Sparkleberry Runner [ Wed Jul 22, 2009 6:20 pm ] |
| Post subject: | replacing PD hyrdo line |
I'm a little confused...I trim the motor all the way up and bump it down a tad to take the pressure off cylinder and continue to take the line off? Or do i have to unhook anything else? anyone know? thanks |
|
| Author: | Mitschke [ Wed Jul 22, 2009 6:31 pm ] |
| Post subject: | Re: replacing PD hyrdo line |
Trim all the way down, bump the switch up to relieve pressure then take'm off. |
|
| Author: | douchepickle [ Thu Jul 23, 2009 12:23 pm ] |
| Post subject: | Re: replacing PD hyrdo line |
what he said |
|
| Author: | Sparkleberry Runner [ Thu Jul 23, 2009 6:59 pm ] |
| Post subject: | Re: replacing PD hyrdo line |
How do i purge the lines? |
|
| Author: | Mitschke [ Thu Jul 23, 2009 9:52 pm ] |
| Post subject: | Re: replacing PD hyrdo line |
Put one finger on one end of the line and pour some dexron 3 on the open end of the line. Release your fingers and as quick as you can put the line back into the right place... Viola!!! LOL JK hahhahaa Just run it up and down a few times, check the fluid level you will prolly need to add some fluid (dexron 3) then run it up and down some more. The air pockets will work out real fast. |
|
| Author: | Sparkleberry Runner [ Sat Jul 25, 2009 3:12 pm ] |
| Post subject: | Re: replacing PD hyrdo line |
thanks Mitschke got it hooked up yesterday |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|