19'x48'
19" sides
19" transom
80" deck
troll motor plate
LED shark running lights
handles on transom, handles on bow
8ft removable bow fish rails
48" removable polling platform with rails
090. raised panel double bottom floor with gutters
14 gal gas tank
removable 16"x40" cross box with dry storage with drains
switch panel
painted dark green
all 1/8
razor chine
trim tab
removable grab bar
auto bilge pump
fishing pedestal on bow
drivers pedestal
fish pedestal at the stern.

$6150

Good looking rig

Thank ya. Next pics will be finished product

Oh yea and I forgot about the spud holes

Nice boat!!

What exactly is a razor chine?


Sent from my beeper

don't exactly know but that's what he told me it is, ill ask him

Thnx. And I guess. I'll ask him exactly what it is when I go pick it up

Putting a fuel car wing on that thing?

Haha. Just a tall polling platform that he was in the middle of building

Lol I know man just messing with you, that things tall! Nice.

I know man lol. And yea I can't wait. Bout a week or two ledt

boat is looking awesome so far. congrats

I like that pointed front end.

Yea, at first I was gunna go with a flat bow then I rode in a pointed bow trough timber and changed my mind quickly

Is that a true flat bottom withy that pointed of a bow or a hybrid v in the rake. Been contemplating how I would want to do a new boat either flat front or pointed bow. I like the pointed bow that I have now on my crawfish skiff and would like a sharply pointed bow like that if it can keep a true flat bottom.

Pointed bow in timber its the only way to go

.

Yeah okay. you can obviously do a better job of telling me what i run than i can.

I said dead timber. Have you ever seen a n tx lake? They're basically forest that the cut a few lanes in, and flooded. Its just an old rotten forest in the water now. I didnt say i was running over strong green trees, and didnt say anything about running in the swamp.

I like that smooth floor

Yea it's pretty nice

I run dead timber quite often and I'll never go back to a square front, the pointed bow still breaks the weak little stuff.

You are asking to sink a boat if you run over dead trees/stumps much larger than 4-5" often. What are you going to do when you hit a stronger tree that breaks off where the rake hit it 1' above the water and the rake climbs up it putting the transom under water?

Swim...

^^^ haha

Question, most of these boats have longitudinal runners and a few braces running across the top of the runners tying into the sides of the boat. Every mad man boat I have seen so far, the cross braces do not tie in to the sides of the boat. I have owned one (not mad man) like this and the bottom and sides flexed pretty bad in the rough water and over stumps. Is this the case with these boats? Seems like it should be tied in creating a "strongback" to reduce flexing. Just curious.

I've only taken it out once and it was just in a bayou, I doubt that any of that would happen though, it's a very solid built boat. I've got a buddy who has one and he has run it through the gauntlet and he has been nothing but pleased with it, he said the hull is very solid and well built

I'm willing to bet the side will flex some

Well like I said I haven't really gotten to take mine out, all I'm doin is working right now, and my buddy is rough on equipment he pushes everything hard and he has had no complaints and no problems with it.