| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| braaaaapp! https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=52929 |
Page 1 of 1 |
| Author: | fowllife08 [ Sat May 03, 2014 5:30 am ] |
| Post subject: | braaaaapp! |
Did a little searchin and couldnt find much. On the newer GTR'S i beleive it has 4 holes correct? Which hole are yall putting it in for best results? |
|
| Author: | calphil [ Sat May 03, 2014 5:34 am ] |
| Post subject: | Re: braaaaapp! |
My 25 is on top with a quick pin .. Stock pin in bottom for when mud gets tic |
|
| Author: | Nate [ Sat May 03, 2014 5:40 am ] |
| Post subject: | Re: braaaaapp! |
gonna vary depending on your boat and transom...but whatever pin it runs best on make sure you have a removable pin so you can drop all the way down if necessary, this has gotten me out of a bind many times |
|
| Author: | fowllife08 [ Sat May 03, 2014 5:43 am ] |
| Post subject: | Re: braaaaapp! |
So factory pin on bottom hole and 'removable' on desired hole? Just askin because i nwver understood it the holes made that much of a diference? Bout to make a makeshift pin. Can someone measure the width of the transom mount? So i can drill a hole for cotter? Thanks! |
|
| Author: | Gameover [ Sat May 03, 2014 8:03 am ] |
| Post subject: | Re: braaaaapp! |
The 4th hole added was out lower than the previous ones so new models go extra low. And in mud pin location helps drastically it allow u to trim much lower |
|
| Author: | doubleBanded [ Sat May 03, 2014 10:22 am ] |
| Post subject: | Re: braaaaapp! |
Mine runs in second pin |
|
| Author: | KeNnY [ Sun May 04, 2014 9:28 am ] |
| Post subject: | Re: braaaaapp! |
Mine is in the second one as well Sent from my SAMSUNG-SGH-I337 using Tapatalk |
|
| Author: | MarshJB [ Sun May 04, 2014 10:33 am ] |
| Post subject: | Re: braaaaapp! |
| Author: | doubleBanded [ Sun May 04, 2014 11:13 am ] |
| Post subject: | Re: braaaaapp! |
| Author: | tinman454 [ Sun May 04, 2014 11:20 am ] |
| Post subject: | Re: braaaaapp! |
Can some one put up a pic of this pin thing I don't understand how this works. Do you need to pull a pin out when you need to trim the motor ? Or is it to hold the motor up after you trim? What is this pin for? |
|
| Author: | doubleBanded [ Sun May 04, 2014 6:09 pm ] |
| Post subject: | Re: braaaaapp! |
| Author: | doubleBanded [ Sun May 04, 2014 6:11 pm ] |
| Post subject: | Re: braaaaapp! |
. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|