| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| not so smooth https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=5510 |
Page 1 of 1 |
| Author: | OwenDickeson [ Tue Oct 20, 2009 4:43 pm ] |
| Post subject: | not so smooth |
i noticed that when playin around in my boat yesterday that if i was goin around 10 mph or so there was alot of vibration and when i gas it there is alot of vibration almost the the point of shaking. i do not remember my old motor being like that and was wondering if its something i should contact pro-drive about. |
|
| Author: | DeathMetalDukk [ Tue Oct 20, 2009 4:50 pm ] |
| Post subject: | Re: not so smooth |
Sounds like something's out of balance. I'd give them a call. |
|
| Author: | shallow water master [ Tue Oct 20, 2009 4:51 pm ] |
| Post subject: | Re: not so smooth |
| Author: | OwenDickeson [ Tue Oct 20, 2009 4:52 pm ] |
| Post subject: | Re: not so smooth |
brand new motor. think the prop could be out of balance from the factory? |
|
| Author: | DeathMetalDukk [ Tue Oct 20, 2009 4:54 pm ] |
| Post subject: | Re: not so smooth |
Does it do it out of water? If so, take the prop off and see if it still does it, maybe you can narrow it down. |
|
| Author: | OwenDickeson [ Tue Oct 20, 2009 4:59 pm ] |
| Post subject: | Re: not so smooth |
just ran it out of water and i doesnt seem to sound right around 2000 rpms. i think im going to grab my cousins prop and try it out tomorrow....other than that any suggestions from anyone? |
|
| Author: | shallow water master [ Tue Oct 20, 2009 5:01 pm ] |
| Post subject: | Re: not so smooth |
| Author: | Brinkleydog [ Tue Oct 20, 2009 6:49 pm ] |
| Post subject: | Re: not so smooth |
take it back to them......u didnt pay all that money to have to jack with it did ya. Take good care of your! |
|
| Author: | OwenDickeson [ Tue Oct 20, 2009 7:16 pm ] |
| Post subject: | Re: not so smooth |
| Author: | POKER1 [ Tue Oct 20, 2009 7:33 pm ] |
| Post subject: | Re: not so smooth |
| Author: | dead animal [ Wed Oct 21, 2009 10:00 pm ] |
| Post subject: | Re: not so smooth |
get out the grease gun and grease ur motor where-ever there is a zerk. it will stop the vibration. |
|
| Author: | OwenDickeson [ Thu Oct 22, 2009 5:44 pm ] |
| Post subject: | Re: not so smooth |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|