| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Bunk Boards https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=6670 |
Page 1 of 1 |
| Author: | Short On Cache [ Mon Dec 21, 2009 8:16 am ] |
| Post subject: | Bunk Boards |
I noticed this weekend that I have a broken bunk board. Has anyone ever tried the synthetic deck boards? If not that I am considering some treated boards with polyurethane. I am done with carpet. I do want them the boat to slide a little better. FYI my boards sit 1 1/2 on top not 3 1/2 so im not thinking I can use the slick poly things on the boards. Id like to hear your thoughts. |
|
| Author: | Mag10 [ Mon Dec 21, 2009 9:38 am ] |
| Post subject: | Re: Bunk Boards |
For about the same cost as the deck boards, try ultimate bunk boards. They are a HDPE 2X4 or 2X6. Have been using them for 2 years with good luck. http://www.ultimatebunkboards.com/ Mag10 |
|
| Author: | Tcounty [ Mon Dec 21, 2009 10:01 am ] |
| Post subject: | Re: Bunk Boards |
| Author: | POKER1 [ Mon Dec 21, 2009 11:22 am ] |
| Post subject: | Re: Bunk Boards |
I would go with the 2x6 over the deck boards for better strength. Depending on cross brace spacing deck boards may sag. I have 4 treated 2x6s laying flat. At 9' that would cost over 300.00 for those fancy bunk boards. The synthetic type deck boards are not stiff enough unless you have multiple cross braces on your trailer. |
|
| Author: | Mag10 [ Mon Dec 21, 2009 12:24 pm ] |
| Post subject: | Re: Bunk Boards |
I used a 1 1/2" X 1 1/2" X 1/8" angle under the bunks. I used a spade bit to counterbore the heads of the carriage bolts and washers below the surface. The high density polyethelene is pretty rugged, even in below zero temps. Mag10 |
|
| Author: | Skipr [ Mon Dec 21, 2009 5:52 pm ] |
| Post subject: | Re: Bunk Boards |
My Magic Tilt came with a plastic cover on the 2x4 bunks instead of carpet. This boat slides on and off better than my last boat on carpet covered bunks. |
|
| Author: | LaBirdman [ Thu Dec 24, 2009 11:18 am ] |
| Post subject: | Re: Bunk Boards |
Put you some cypress on there and be done. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|