| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Prodrive Tiller handle extension https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=9975 |
Page 1 of 1 |
| Author: | tman52804 [ Tue Jun 01, 2010 12:05 pm ] |
| Post subject: | Prodrive Tiller handle extension |
Anyone have a picture of the tiller handle extension they can post. I just bought a new 2010 36hp prodrive and I'm thinking about making the extension. |
|
| Author: | deadbird8 [ Tue Jun 01, 2010 9:20 pm ] |
| Post subject: | Re: Prodrive Tiller handle extension |
cccc |
|
| Author: | POKER1 [ Tue Jun 01, 2010 9:47 pm ] |
| Post subject: | Re: Prodrive Tiller handle extension |
No pics but the hard part I imagine would be milling or making the stainless shaft. The other part is just the aluminum pipe housing extension to weld on. Take yours apart and you can easily see the couple pieces needed. You could use the bushing thats already in it. And dont put any petrolium based lubricants on those bushing. Doesn't take but about 5 minutes at most to pull it apart the first time. Remove the bolt at the rear, pull the linkage arm off and slide the shaft out the front. |
|
| Author: | idabilly [ Thu Jun 03, 2010 8:23 am ] |
| Post subject: | Re: Prodrive Tiller handle extension |
I had one on my motor, then I got a different hull. It is laying around here somewhere. I'd be willing to give you a heck of a deal if I can find it (think I can). How much are those things going for these days? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|