| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Oil plug on a 36 PD https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=1961 |
Page 1 of 1 |
| Author: | Sparkleberry Runner [ Thu May 07, 2009 11:30 am ] |
| Post subject: | Oil plug on a 36 PD |
i know this is a dumbass question but where is it located? is it the square end plug by the oil filter or what? |
|
| Author: | RC [ Thu May 07, 2009 1:38 pm ] |
| Post subject: | Re: Oil plug on a 36 PD |
16mm flangehead bolts, one on the left and right sides of the bottom of the block, couple inches above the aluminum plate the engine is bolted to, kinda under the oil filter (Not the square headed little bolt/plug). I always used a paper plate tucked under the block to drain the oil in a bucket and not get it all over the plate/clutch/floor. |
|
| Author: | Sparkleberry Runner [ Thu May 07, 2009 5:31 pm ] |
| Post subject: | Re: Oil plug on a 36 PD |
| Author: | GaugeTheDuckDog [ Thu May 07, 2009 6:29 pm ] |
| Post subject: | Re: Oil plug on a 36 PD |
do you have to drain oil from both sides |
|
| Author: | Sparkleberry Runner [ Thu May 07, 2009 6:57 pm ] |
| Post subject: | Re: Oil plug on a 36 PD |
I took the plug out on the oil filter side. looked to me as if 2 quarts came out. |
|
| Author: | RC [ Thu May 07, 2009 7:35 pm ] |
| Post subject: | Re: Oil plug on a 36 PD |
| Author: | BROOKS [ Thu May 07, 2009 8:49 pm ] |
| Post subject: | Re: Oil plug on a 36 PD |
You Know ???? What's real cool is that you can hang out in yore front yard and change the oil in yore High-Performance MudMotorMachineThang and ... actually feel like yore a ....... "Wrench" !!!!!  I'm guilty ..... I've done it !!!!!! Even rev'd the RPM's and ticked of the nabor's dawg !!!!! ........ dang-it Boy !!!!!!
|
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|