| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| smaller godevil motor swaps? https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=2635 |
Page 1 of 1 |
| Author: | headshot [ Wed Jun 17, 2009 3:53 pm ] |
| Post subject: | smaller godevil motor swaps? |
what is the hp limit for a bolt on application for a 6hp go devil motor? if i took a 5-6 hp godevil longtail, how large of a motor can i swap out on the frame? thanks |
|
| Author: | Mud Slinger [ Wed Jun 17, 2009 6:02 pm ] |
| Post subject: | Re: smaller godevil motor swaps? |
better call GD for that |
|
| Author: | mcnemar1982 [ Wed Jun 17, 2009 8:45 pm ] |
| Post subject: | Re: smaller godevil motor swaps? |
| Author: | basinlover [ Wed Jun 17, 2009 8:59 pm ] |
| Post subject: | Re: smaller godevil motor swaps? |
When I used to build my own if you had a 5  hp briggs you can put a 10 tecumshi in its place they hadd the same bolt pattern and shaft height but the shaft was 1" instead of 3/4" but not sure bout what you have, you can also go to nortern tool and look up the engine specs where they will give you heights and stuff.
|
|
| Author: | headshot [ Thu Jun 18, 2009 4:42 pm ] |
| Post subject: | Re: smaller godevil motor swaps? |
i spoke with GD they said only up to a 6.5 on this frame. not sure if thats said for liability or function. my jonboats say 25 hp outboard but i run 35 on them. guess ill have to look around take some measurments |
|
| Author: | Mud Slinger [ Thu Jun 18, 2009 8:39 pm ] |
| Post subject: | Re: smaller godevil motor swaps? |
liabillty is a lot of things from mm mfgs Im sure |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|