pretty sure that's why there's torque specs
seriously though... I have no clue. might as well trick it out now poo-poo
| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| found out what my problem has been https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=2649 |
Page 1 of 1 |
| Author: | Crews [ Thu Jun 18, 2009 7:45 am ] |
| Post subject: | found out what my problem has been |
the tape measure doesnt lie... ive got a lobe on my cam shaft thats flat. its not opening up one of my exhaust valves. |
|
| Author: | Full Throttle [ Thu Jun 18, 2009 8:16 am ] |
| Post subject: | Re: found out what my problem has been |
Is that a stock cam or aftermarket? The reason I ask is it seems as if some of the aftermarket ones have been having that same problem..... |
|
| Author: | Crews [ Thu Jun 18, 2009 9:18 am ] |
| Post subject: | Re: found out what my problem has been |
stock cam. trying to decide if tightening up the rocker arm too tight on reassembly after headwork might have caused the lifter to not go up and down like it should... |
|
| Author: | T-mac [ Thu Jun 18, 2009 10:33 am ] |
| Post subject: | Re: found out what my problem has been |
pretty sure that's why there's torque specs seriously though... I have no clue. might as well trick it out now poo-poo
|
|
| Author: | RC [ Thu Jun 18, 2009 11:36 am ] |
| Post subject: | Re: found out what my problem has been |
| Author: | deadbird8 [ Thu Jun 18, 2009 12:38 pm ] |
| Post subject: | Re: found out what my problem has been |
That sucks. Bright side is you might as well upgrade the cam while you have it apart. |
|
| Author: | craig [ Thu Jun 18, 2009 7:40 pm ] |
| Post subject: | Re: found out what my problem has been |
Seems like a few people have had cam issues lately. |
|
| Author: | 50fps [ Fri Jun 19, 2009 5:52 am ] |
| Post subject: | Re: found out what my problem has been |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|