| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Minkui idel screw https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=70265 |
Page 1 of 1 |
| Author: | Duck-killa [ Fri Apr 14, 2017 9:28 pm ] |
| Post subject: | Minkui idel screw |
I started my motor and let it it warm up and set up the idel too 950 and then I shut it off. I came back to start it before I left my house to ride and let it warm up and it was running like 1800 rpms and I tired lowering it but I can't get it down past 1540 rpms even unscrewing the screw a lot, any ideas ? |
|
| Author: | Will C [ Fri Apr 14, 2017 10:02 pm ] |
| Post subject: | Re: Minkui idel screw |
Cable to tight. Cable jump pulley?Pull filter and make sure idel screw is moving the silde up and down when adjusting |
|
| Author: | cb5331 [ Sat Apr 15, 2017 8:39 am ] |
| Post subject: | Re: Minkui idel screw |
God damn Louisiana education system fails us again. |
|
| Author: | brycecheramie [ Sat Apr 15, 2017 8:41 am ] |
| Post subject: | Re: Minkui idel screw |
| Author: | ibfishinb [ Sat Apr 15, 2017 12:31 pm ] |
| Post subject: | Re: Minkui idel screw |
Lol... "Idel" .... from 2 different people in the same post. Classic. Sent from my SM-G920V using Tapatalk |
|
| Author: | cb5331 [ Sat Apr 15, 2017 1:25 pm ] |
| Post subject: | Re: Minkui idel screw |
There might be one or two more issues... |
|
| Author: | Will C [ Sat Apr 15, 2017 4:13 pm ] |
| Post subject: | Re: Minkui idel screw |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|