How was it with the ridges on the bottom? I've been waiting to see someone with this style bottom

Ribbed bottom lol. I let the first 2 coat go 20min between. But it took me about 30 mins per coat with the ribs so after the third coat I only waited a few minutes before the fourth. It was rock hard by the time I was ready for that fourth coat


Sent from da mud hole

Well bad luck strikes again put the motor back on my boat and no it's only running on one cylinder and blowing black smoke out of the muffler. Bringin her to Calen in the am to see what the damage is. It was running fine when I pulled it off

Just put that bolt on speed so y'all better watch out ImageUploadedByTapatalk1406845179.171411.jpg

Now that you have GG all you need is one cylinder...lol

Got her all fixed it wasn't serious thank god. when I started it at calens it ran fine, they went through it and reset valves and idle. purrs like a kitten and that flag is a safety flag from when I used to race my four wheeler at the dunes

Lesson of the day.

Even with Gator glide thick Lillie's with on a couple inches of water will stop u dry lol.

On my hull anyway

Must have been a long run through them?

But even my in my brothers airboat he could feel them slowing him down the first run through. After we ran it a few times it was a breeze

Well the boats in the shop with a list of boo boo's

Valves leaking 60%
Have to recut heads
Broken throttle linkage,
Leaking case gasket
Blown lower unit seals
Clutch is shot
And caliper upgrade

My wife and my wallet hate me

Found some play stuff while tryin my reworked prop http://youtu.be/HUkY0k9QMLY

My trim motor went out today while I was in this shit and I was stuck trimmed all the way down. Had to run back to the landing like that and I found every log between mud cove and the Charenton landing. Ended up slightly bending my prop ImageUploadedByTapatalk1418357605.531786.jpg