| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| New to Boats https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=50776 |
Page 1 of 1 |
| Author: | OneShotWillie [ Tue Feb 25, 2014 8:48 am ] |
| Post subject: | New to Boats |
I am new to Hunting just started last year and I love duck hunting so for this year I bought a boat and trailer and I am looking for a engine. I have a 14x52 Duratech its mostly flat on bottom but v's out at the bow its very light maybe 125 to 150 but doesnt have any ratings on it as far as what size engine it can hold. I was thinking about a 7hp stump jumper but I will most likely be out with 2 to 3 people in the boat when I go out all wieghing about 200 LBS Im not sure what weight engine I can put on the back I liked the 10 hp copperhead surface drive but it weighs 110 LBS wasnt sure if it was too much for the boat im lost right now and trying to figure this out any help would be appreaciated thank you. |
|
| Author: | WhoDat88 [ Tue Feb 25, 2014 10:24 am ] |
| Post subject: | Re: New to Boats |
I would get the 23hp backwater longtail if I were you. It would perform on that boat well. |
|
| Author: | HUNT4DEER [ Tue Feb 25, 2014 12:37 pm ] |
| Post subject: | Re: New to Boats |
mesure it at the bottom i beleave 14x52 is at the top of the transom. that would be the beam. its likely a 14x48 or 42. either way it will float upto a 23hp sd. |
|
| Author: | Woodiebuster [ Tue Feb 25, 2014 9:13 pm ] |
| Post subject: | Re: New to Boats |
If it is a 52 inch bottom, slap a 35 on that biotch and roll |
|
| Author: | Bigrich [ Tue Feb 25, 2014 9:15 pm ] |
| Post subject: | Re: New to Boats |
| Author: | Mike J [ Tue Feb 25, 2014 9:52 pm ] |
| Post subject: | Re: New to Boats |
| Author: | btmannin [ Wed Feb 26, 2014 12:58 am ] |
| Post subject: | Re: New to Boats |
| Author: | mud slinger 69 [ Wed Feb 26, 2014 5:36 am ] |
| Post subject: | Re: New to Boats |
You'll be alright with a 10-23 hp motor if it's really 52" wide at the bottom. |
|
| Author: | Buzz Killington [ Wed Feb 26, 2014 6:08 am ] |
| Post subject: | Re: New to Boats |
18hp copperhead will run great on that boat |
|
| Author: | petrel [ Wed Feb 26, 2014 6:17 am ] |
| Post subject: | Re: New to Boats |
http://www.duratechboats.com/pb/wp_3e83 ... 3b1fc.html There is an old spec sheet on their page that may help you determine the model and capacity of the boat. |
|
| Author: | mud slinger 69 [ Wed Feb 26, 2014 6:54 am ] |
| Post subject: | Re: New to Boats |
Just measure the bottom of in the back. |
|
| Author: | OneShotWillie [ Thu Feb 27, 2014 8:29 am ] |
| Post subject: | Re: New to Boats |
I Measured the bottom of the back of the Boat and its 45 inches the top of the transom is 49 inches I aslo emailed the Duatech people with the model # and asked for the specs. |
|
| Author: | OneShotWillie [ Fri Feb 28, 2014 9:48 am ] |
| Post subject: | Re: New to Boats |
Havent got a email from duratech but from doing some research I believe its a Viking 14 not absolute though if so it is rated for a 3 to 10 hp which limits me but one of my buddies just told me to reinforce my transom with some marine grade plywood but i dont know how safe that is probably just going to go with the copperhead 10 hp SD what do you guys think ? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|