|
FAQ
• Login
|
|
It is currently Mon Jul 14, 2025 1:19 pm
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Author |
Message |
krazo
MMT Addict
Joined: Thu Sep 06, 2012 8:44 pm Posts: 667 Location: SE Bama
|
 Polling platform
I'm thinking about adding a polling platform to my new boat but I don't want to drill hunt deck . I will have spud hole welded to back and rear cat walks. I was think about using those for it to set in in the back. Anybody got any ideas? Boat is 1754
_________________ 1754 prodigy- stage 2 GTR
|
Fri Mar 14, 2014 8:31 am |
|
 |
DmaxHunter
MMT 1000 Club
Joined: Wed Jan 18, 2012 7:21 pm Posts: 2207 Location: North Alabama
|
 Re: Polling platform
You getting the gunnel on huntdeck, could attach to there.
_________________ 2014 PRODIGY 1754 (#19) 2014 5500 BAMF HDR RETRO SOLD
2010 Gator Tail Gator Series 18x54 pushed by a 2020 40GTRXD
|
Fri Mar 14, 2014 8:47 am |
|
 |
krazo
MMT Addict
Joined: Thu Sep 06, 2012 8:44 pm Posts: 667 Location: SE Bama
|
 Re: Polling platform
Yes but I don't want to drill holes. I'm think I want holes made into the boat that it just sets in and pins.maybe drill one hole in gunnel on both sides to keep the rattle down
_________________ 1754 prodigy- stage 2 GTR
|
Fri Mar 14, 2014 8:53 am |
|
 |
DmaxHunter
MMT 1000 Club
Joined: Wed Jan 18, 2012 7:21 pm Posts: 2207 Location: North Alabama
|
 Re: Polling platform
You can drill and tap gunnel, without actually putting holes into hull. This is what i had in mine, tap em bolt it down, remove when not needed. Sure Chad would have some ideas aswell
_________________ 2014 PRODIGY 1754 (#19) 2014 5500 BAMF HDR RETRO SOLD
2010 Gator Tail Gator Series 18x54 pushed by a 2020 40GTRXD
|
Fri Mar 14, 2014 9:32 am |
|
 |
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 85 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|