Production runs are in ready to ship! We are also taking dealer applications as well.

MB should be all over this Looks good Corey nice craftsmanship

Pic from a customer on a pro drive.

Guess you'd need one for a motor without travel lock. Those pics have the skeg really low for trailering, looks like its lower than the trailer. Wouldn't you want it up farther so you don't bottom out the motor (like when coming out a steep driveway)?

I know the copperhead pic is above because I installed it lol must be the pic angle. not sure on the pro drive.... Customer sent me a pic.
The support is fully adjustable to trailer at your desired height. Some motors come with a travel lock but the main reason for the support is to take the stress off of the transom and motor bushings.

These are nice Corey. There are countless transom savers for out board but this is the fist I've seen for surface drives. Got to be way more effective than the travel lock. I hate the fact that the motor is just hanging on the transom while bouncing down the highway. Now that I've seen it I want one! Will call you tomorrow.

Do u make one that fits over a roller on the trailer??


Sent from my iPhone using Tapatalk

i made a similar one on a buddys prodrive and the problem i kept running into was the pins kept bending but other then that it worked good

Daddy mallard........ I'm sure one of the universal roller adapters would bolt in our square tube but the pin mount is what keeps the motor from bouncing up...... Unless you have a pro drive with the reverse lock engaged.

GatorDubea......... Our first design bent the pins pretty bad.... This one has an adjustable angle and the only time I've bent one was when my drunk buddy got trim happy lol.

Sounds good!! Ordered one today!


Sent from my iPhone using Tapatalk

This has probably been posted, but do you have any pics on a GTR? Where do the rubber bungies end up with the reverse plate?

How much are these?

Thanks

Best pic I've got of the gtr at the moment. Their $130 and we have them in stock.

Do you offer one with a yoke or something to allow it to clear the trailer ID lights?

Petrel...... I'm sure I could whip something up if you sent pics of what your working with. You can send them to cottonmouthcustomboats@yahoo.com

Pods on a GTR? Can't believe the mods didn't delete that photo.

Pooldoo73..... Recessed transom not pods.