| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| will it fit? https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=66915 |
Page 1 of 1 |
| Author: | Buckmark311 [ Thu May 19, 2016 10:00 am ] |
| Post subject: | will it fit? |
I have a 1436 being pushed by a hopped up 420cc SPS kit. I want to put a beavertail blind on it but am not sure if it will work with the tiller handle on the motor and the blind flipping over. Soooo question of the day, will it work? |
|
| Author: | KJH [ Thu May 19, 2016 12:10 pm ] |
| Post subject: | Re: will it fit? |
Will it fit- Thats what she said. |
|
| Author: | brycecheramie [ Thu May 19, 2016 6:10 pm ] |
| Post subject: | Re: will it fit? |
Short answer, Yes. Long answer, you will have to modify a lot of the frame of the blind to fit your boat. I wouldn't be spending that kinda money on a blind, just to cut it up and make it fit your boat. Make your own, its easy and a lot cheaper |
|
| Author: | Buckmark311 [ Mon May 23, 2016 11:06 am ] |
| Post subject: | Re: will it fit? |
I got the blind for $200, wouldn't spend $700 on one new.... what are you thinking that i'm going to need to modify? |
|
| Author: | flint87 [ Mon May 23, 2016 11:13 am ] |
| Post subject: | Re: will it fit? |
| Author: | krazo [ Tue May 24, 2016 10:29 am ] |
| Post subject: | will it fit? |
Yes it will work. You will just spin the handle out of the way and flip blind up. Then when you need to move flip blind down and motor around. If you are worried about it being too wide it is easy to cut down to make the clamps grab and you will not have to mess with the flip pipes or material. Sent from my iPad using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|