| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Building it.... https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=71505 |
Page 1 of 1 |
| Author: | FNG [ Fri Nov 03, 2017 7:50 am ] |
| Post subject: | Building it.... |
I searched like a demon for the specific answers so please y'all; don't blast me... I'm building a short shaft mud motor, 18hp, belt drive, on probably a 12' flat bottom. I know that with long tails, transom height and shaft length relationship is very important, but on the short shaft I can make my belt housing whatever height I need so I'm not sweating that part. I'm needing two specific pieces of info: 1) is there a standard /better length for the prop shaft on a short tail setup and 2) when the engine is fully at rest and trim is bottomed out, what should the downward angle of the shaft be? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|