Do you have the new style Lu with grease zirk? Also did you wash the motor down using a lot of water around the clutch? There is a vent inside the tower that lets water into Lu. Happened to me filled Lu with water right after changing oil.
| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Oil in my PD lower unit Q https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=26678 |
Page 1 of 1 |
| Author: | fredthewelder [ Sun Feb 12, 2012 7:09 pm ] |
| Post subject: | Oil in my PD lower unit Q |
I changed my lower unit oil after a hard run duck season When it came out of hole it was pure white I used mobil synth 75/90 or something like that My question is why white am I getting a leak in lower unit Please advise |
|
| Author: | duckduckboom [ Sun Feb 12, 2012 7:14 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
did you run it within 24 hours of drain it |
|
| Author: | mizzippi jb [ Sun Feb 12, 2012 7:17 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
prob. need to change out the prop nut seal. Pro drive will send you one for 125 and you can mail the old one back to e, they will mail you a check back for $55. also turns milky if you have run recently, something to consider. |
|
| Author: | fredthewelder [ Sun Feb 12, 2012 7:44 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
| Author: | duckduckboom [ Sun Feb 12, 2012 7:45 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
as long as you did not put it in gear. change 3 lower seals |
|
| Author: | fredthewelder [ Sun Feb 12, 2012 7:56 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
| Author: | OwenDickeson [ Sun Feb 12, 2012 8:01 pm ] |
| Post subject: | Oil in my PD lower unit Q |
Let it sit for a few days and check it again, don't run the motor before you check it. |
|
| Author: | duckduckboom [ Sun Feb 12, 2012 8:02 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
well it acts like a blender in there and traps air when the gears spin. i personally would refill it and go. run it a few times let it settle then check it again. if it is cloudy then i would proceed with the changing of three seals. |
|
| Author: | JIMMY W [ Sun Feb 12, 2012 9:34 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
Seals! |
|
| Author: | fredthewelder [ Mon Feb 13, 2012 4:08 am ] |
| Post subject: | Re: Oil in my PD lower unit Q |
Ok so how hard is it to change them Any special tools needed |
|
| Author: | johnny rebel [ Mon Feb 13, 2012 6:26 am ] |
| Post subject: | Re: Oil in my PD lower unit Q |
Do you have the new style Lu with grease zirk? Also did you wash the motor down using a lot of water around the clutch? There is a vent inside the tower that lets water into Lu. Happened to me filled Lu with water right after changing oil.
|
|
| Author: | cb5331 [ Mon Feb 13, 2012 11:19 am ] |
| Post subject: | Re: Oil in my PD lower unit Q |
| Author: | fredthewelder [ Mon Feb 13, 2012 5:15 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
Ya that makes since I'll run it for walley season see how it dose Thank u all for the info |
|
| Author: | POKER1 [ Mon Feb 13, 2012 6:18 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
If it makes you feel any better, just drain it again and refill. You will have lost all of 30 minutes and $3.00. |
|
| Author: | JIMMY W [ Thu Feb 16, 2012 7:25 am ] |
| Post subject: | Re: Oil in my PD lower unit Q |
| Author: | OwenDickeson [ Thu Feb 16, 2012 7:35 am ] |
| Post subject: | Oil in my PD lower unit Q |
| Author: | POKER1 [ Thu Feb 16, 2012 12:12 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
| Author: | JIMMY W [ Thu Feb 16, 2012 1:25 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
Damn poodrives! |
|
| Author: | OwenDickeson [ Thu Feb 16, 2012 1:37 pm ] |
| Post subject: | Oil in my PD lower unit Q |
| Author: | duckduckboom [ Thu Feb 16, 2012 1:38 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
| Author: | fredthewelder [ Thu Feb 16, 2012 1:44 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
It amazes me how u guys get off topic so quick with bullish!!!t Wow no thread hijacking |
|
| Author: | OwenDickeson [ Thu Feb 16, 2012 1:49 pm ] |
| Post subject: | Oil in my PD lower unit Q |
Fred, I thought we got your situation figured out. Jimmy, Suck it. |
|
| Author: | duckduckboom [ Thu Feb 16, 2012 2:09 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
Fred we answered your question was answered three times by three diffrent people |
|
| Author: | JIMMY W [ Thu Feb 16, 2012 2:35 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
| Author: | OwenDickeson [ Thu Feb 16, 2012 3:00 pm ] |
| Post subject: | Oil in my PD lower unit Q |
| Author: | fredthewelder [ Thu Feb 16, 2012 3:36 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
Wow a little ribbing and the aholes show there teeth wow Calm down |
|
| Author: | MaXXis85 [ Thu Feb 16, 2012 3:40 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
| Author: | OwenDickeson [ Thu Feb 16, 2012 3:43 pm ] |
| Post subject: | Oil in my PD lower unit Q |
lol |
|
| Author: | T-Bubba [ Thu Feb 16, 2012 6:13 pm ] |
| Post subject: | Re: Oil in my PD lower unit Q |
if you do change the nut seal... remember its left handed threads |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|