| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| pully problems https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=29143 |
Page 1 of 1 |
| Author: | gdsd23 [ Thu May 10, 2012 5:33 pm ] |
| Post subject: | pully problems |
pully problems I have a go devil surface drive 23 horsepower. The crank case gasket started to leak oil, so i figured i would try and change it my self. Everything was goin good until i went to take the top drive pulley off. I dont see any set screws on the pulley and i took the two allen head bolts out of pulley. I tried three different wheel pullers doesnt wanna budge. Any thing im doin wrong? Any advise would be appreciated. |
|
| Author: | autogateman [ Thu May 10, 2012 8:47 pm ] |
| Post subject: | pully problems |
Put one of he Allen screws in the third threaded hole and tighten. When it's as tight as it will go, tap the pulley toward the engine. |
|
| Author: | yippee [ Sun May 27, 2012 11:39 am ] |
| Post subject: | Re: pully problems |
gdsd23 thanks for asking this question and autogateman thanks for the perfect reply as I was having the same problem today and that thing came off like butter with your advice. thanks again. |
|
| Author: | sftull [ Tue May 29, 2012 6:59 am ] |
| Post subject: | Re: pully problems |
Wish this would have seen this a few days ago. Didn't think I was ever going to get the top pulley off. |
|
| Author: | chaseh [ Tue May 29, 2012 8:17 am ] |
| Post subject: | pully problems |
Hahaha. The fun part is getting it back on. IT always gives me more trouble.... |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|