You shouldn't need new ones though since they can't break...
**Sent from my Obama Phone**
| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Aftermarket pulleys ? https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=36198 |
Page 1 of 1 |
| Author: | genson [ Wed Jan 09, 2013 2:31 pm ] |
| Post subject: | Aftermarket pulleys ? |
Is there anywhere to get pulleys for gdsd other than gd |
|
| Author: | cb5331 [ Wed Jan 09, 2013 3:03 pm ] |
| Post subject: | Re: Aftermarket pulleys ? |
Yes, but if I told you where, it might cause giga to have a seizure and I don't see any reason why coco should have his dick chewed off. |
|
| Author: | CootSlayerRMFT [ Wed Jan 09, 2013 3:12 pm ] |
| Post subject: | Re: Aftermarket pulleys ? |
| Author: | autogateman [ Wed Jan 09, 2013 4:09 pm ] |
| Post subject: | Re: Aftermarket pulleys ? |
Motion industries |
|
| Author: | CootSlayerRMFT [ Wed Jan 09, 2013 4:13 pm ] |
| Post subject: | Re: Aftermarket pulleys ? |
You shouldn't need new ones though since they can't break... **Sent from my Obama Phone** |
|
| Author: | HH_Kennels [ Wed Jan 09, 2013 6:36 pm ] |
| Post subject: | Re: Aftermarket pulleys ? |
bearing supply in Longview or Shreveport, if they don't have them in stock, i bet they can get them. motion industries in longview is higher than giraffe pussy... and they have very limited stock from my experience... |
|
| Author: | genson [ Thu Jan 10, 2013 12:17 pm ] |
| Post subject: | Re: Aftermarket pulleys ? |
Goin to a 3 blade gd says u gotta change the reduction if i come factory with 3 blade |
|
| Author: | rudyeng [ Fri Jan 11, 2013 8:03 pm ] |
| Post subject: | Re: Aftermarket pulleys ? |
Ebay. Enter timing belt pulley. good luck. |
|
| Author: | genson [ Sat Jan 12, 2013 4:18 pm ] |
| Post subject: | Re: Aftermarket pulleys ? |
Does anyone no what size pulleys the 3 blade 23 gdsd runs |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|