| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| GD prop tool - DIY https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=36875 |
Page 1 of 1 |
| Author: | chaseh [ Sat Jan 26, 2013 12:58 pm ] |
| Post subject: | GD prop tool - DIY |
Had hell getting my prop off. So I built this tool out of a 2.6" outer spindle nut socket. I used a die grinder to cut out the grooves that matched the 3 blade perfect. still had to use heat, but it worked like a champ. Now I'm going to try the 2 blade! Socket was 9.99 at oreillys |
|
| Author: | Howdy [ Sat Jan 26, 2013 5:41 pm ] |
| Post subject: | Re: GD prop tool - DIY |
Now how are you going to get the spindle nuts off your truck lol just kidding man. Great idea i love making my own tools |
|
| Author: | bayouboy [ Fri Feb 01, 2013 6:46 pm ] |
| Post subject: | Re: GD prop tool - DIY |
NICE! |
|
| Author: | OwenDickeson [ Fri Feb 01, 2013 6:50 pm ] |
| Post subject: | Re: GD prop tool - DIY |
Good job dude, thats slick. |
|
| Author: | BAG Hunter [ Fri Feb 01, 2013 9:14 pm ] |
| Post subject: | Re: GD prop tool - DIY |
May be a dumb question but what stops the shaft from spinning as you spin the prop off? Did you use an impact wrench or big breaker bar? |
|
| Author: | chaseh [ Sun Feb 03, 2013 10:09 am ] |
| Post subject: | Re: GD prop tool - DIY |
| Author: | Buzz Killington [ Fri Feb 08, 2013 2:07 pm ] |
| Post subject: | Re: GD prop tool - DIY |
X2 nice |
|
| Author: | jedisme [ Sun Mar 03, 2013 8:48 pm ] |
| Post subject: | Re: GD prop tool - DIY |
Take the prop nut off (or loosen it up quite a bit) crank your motor up rev it up a few times pull the kill switch I do this my LT and it works. |
|
| Author: | da go get'er [ Sun Mar 03, 2013 11:14 pm ] |
| Post subject: | Re: GD prop tool - DIY |
| Author: | jedisme [ Mon Mar 04, 2013 1:40 am ] |
| Post subject: | Re: GD prop tool - DIY |
I would but.its not stuck. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|