| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| GT rear shaft seals question. https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=39221 |
Page 1 of 1 |
| Author: | BayouStateHunter [ Fri Mar 29, 2013 3:44 pm ] |
| Post subject: | GT rear shaft seals question. |
Do both rear seals open side face the prop on top of each other inside the bearing housing? I couldn't tell the orientation when taking them apart since they were bad off. Thanks in advance. |
|
| Author: | JIMMY W [ Fri Mar 29, 2013 3:46 pm ] |
| Post subject: | Re: GT rear shaft seals question. |
Yes |
|
| Author: | BayouStateHunter [ Fri Mar 29, 2013 4:27 pm ] |
| Post subject: | Re: GT rear shaft seals question. |
Once I try to screw the bearing holder back on the lower unit, the damn wear sleeve wont stay flush with the bearing holder. What am I fucking up? |
|
| Author: | JIMMY W [ Fri Mar 29, 2013 4:29 pm ] |
| Post subject: | Re: GT rear shaft seals question. |
Its not going to be flush,It sticks out a little! |
|
| Author: | BayouStateHunter [ Fri Mar 29, 2013 4:31 pm ] |
| Post subject: | Re: GT rear shaft seals question. |
That's what she said. Thanks. |
|
| Author: | JIMMY W [ Fri Mar 29, 2013 4:31 pm ] |
| Post subject: | Re: GT rear shaft seals question. |
|
|
|
| Author: | BayouStateHunter [ Fri Mar 29, 2013 5:16 pm ] |
| Post subject: | Re: GT rear shaft seals question. |
Thanks for the help. It was my first stab at it. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|