Your brother gonna be mad at you!! But stick to that story and don't deviate!
Sent using Morse Code from my not so smart phone.
| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Need some GTR help https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=43612 |
Page 1 of 1 |
| Author: | goodblasson [ Tue Jul 30, 2013 7:19 am ] |
| Post subject: | Need some GTR help |
I got tasked with bringing my brothers boat to Gatortail to get worked on, needed bearing work and upgraded the reverse to gen 3 while it was there. Picked the boat up and took it out saturday for a ride, all went well. Got home and noticed these bolts hanging from the clutch cover. Pulled clutch cover off and I am pretty sure these bolts go with the bracket that holds the caliper. Anyhow, I would throw it all back together but I am afraid the nuts maybe at the bottom of the belt housing, they are lock nuts so I doubt they would back off on there own. In the case they were only hand tight and fell to bottom of belt housing should I leave them there or tear everything apart to retrieve them. |
|
| Author: | BlueShamu [ Tue Jul 30, 2013 10:48 am ] |
| Post subject: | Re: Need some GTR help |
Your brother gonna be mad at you!! But stick to that story and don't deviate! Sent using Morse Code from my not so smart phone. |
|
| Author: | rubberduck [ Tue Jul 30, 2013 10:55 am ] |
| Post subject: | Re: Need some GTR help |
I'm no rocket scientist but I wouldn't leave chunks of metal near moving mechanical parts for sure. |
|
| Author: | txmudcutter [ Tue Jul 30, 2013 10:56 am ] |
| Post subject: | Re: Need some GTR help |
Looks like they've got new hardware on there. Those could be the old bolts they took out and accidentally left in there. |
|
| Author: | txmudcutter [ Tue Jul 30, 2013 10:56 am ] |
| Post subject: | Re: Need some GTR help |
I'd definitely check in the belt housing for the nuts though |
|
| Author: | goodblasson [ Tue Jul 30, 2013 11:42 am ] |
| Post subject: | Re: Need some GTR help |
I cant see anything in the belt housing, and if they are in there im sure im going to find them under the sprocket and belt. Its SS hardware so a magnet is a no go. I talked to GT and they said throw some nuts on there and run it or bring it in and they will look over it. I just hate to take off from work to make the drive. |
|
| Author: | calphil [ Tue Jul 30, 2013 4:01 pm ] |
| Post subject: | Re: Need some GTR help |
| Author: | Team Camo [ Tue Jul 30, 2013 8:53 pm ] |
| Post subject: | Re: Need some GTR help |
Loosen the 4 nuts (1/2") that hold the engine to the frame. Then remove the nuts holding the outdrive to the belt housing (9/16"). Pull the outdrive off, fish out the 2 lost nuts, put it all back together. Looking at 30 mins, tops. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|