| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| prop question https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=43623 |
Page 1 of 1 |
| Author: | crawfordw2 [ Tue Jul 30, 2013 11:10 am ] |
| Post subject: | prop question |
I have a homemade lt that is made like a gd lt. The shaft is not threaded and neither is the prop that is currently on the motor. Can I run a threaded prop on a non thread shaft? If not where can I find a good prop that is not threaded? |
|
| Author: | T-Bubba [ Tue Jul 30, 2013 11:22 am ] |
| Post subject: | Re: prop question |
try to screw a 1/2" nut on a half inch cold roll |
|
| Author: | Will [ Tue Jul 30, 2013 11:31 am ] |
| Post subject: | Re: prop question |
Post a picture |
|
| Author: | Gtr18x42 [ Tue Jul 30, 2013 11:43 am ] |
| Post subject: | Re: prop question |
If your prop has a shoulder to seat up against it would prolly run in deep water but if put in a bind would most likely slip. Sent from my iPhone using Tapatalk |
|
| Author: | crawfordw2 [ Wed Jul 31, 2013 8:51 am ] |
| Post subject: | Re: prop question |
I cant post a pic as of right now because my boat is at my camp and that is 2 hours away. |
|
| Author: | crawfordw2 [ Tue Aug 06, 2013 3:07 pm ] |
| Post subject: | Re: prop question |
Does anybody have a new 10X6 go devil prop for sale? |
|
| Author: | Gtr18x42 [ Wed Aug 07, 2013 8:19 pm ] |
| Post subject: | Re: prop question |
| Author: | crawfordw2 [ Thu Aug 08, 2013 11:06 am ] |
| Post subject: | Re: prop question |
Thanks Gtr18x42 if you find that serial # send me a PM |
|
| Author: | Gtr18x42 [ Thu Aug 08, 2013 12:25 pm ] |
| Post subject: | Re: prop question |
Will do Sent from my iPhone using Tapatalk |
|
| Author: | Buzz Killington [ Fri Aug 09, 2013 8:24 am ] |
| Post subject: | Re: prop question |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|