MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
Hidden Zerc Fitting on PD Lower Unit Tower? https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=43994 |
Page 1 of 1 |
Author: | shooter [ Fri Aug 09, 2013 9:58 am ] |
Post subject: | Hidden Zerc Fitting on PD Lower Unit Tower? |
There's no access to this grease fitting on my lower unit. I plan to take care of it while I have the LU apart, but should I worry about not having access to this when the LU is installed? |
Author: | OwenDickeson [ Fri Aug 09, 2013 10:48 am ] |
Post subject: | Re: Hidden Zerc Fitting on PD Lower Unit Tower? |
Drill a large hole in the housing, tap it, and plug it. |
Author: | cb5331 [ Fri Aug 09, 2013 11:16 am ] |
Post subject: | Re: Hidden Zerc Fitting on PD Lower Unit Tower? |
Author: | OwenDickeson [ Fri Aug 09, 2013 11:22 am ] |
Post subject: | Re: Hidden Zerc Fitting on PD Lower Unit Tower? |
Look up the Pro-Drive owner's manual on their website, it should show you what it will look like. |
Author: | Quackhead62 [ Fri Aug 09, 2013 11:34 am ] |
Post subject: | Re: Hidden Zerc Fitting on PD Lower Unit Tower? |
On my 09 PD there is a hex head plug that covers the grease zerc like owen is saying. Just pull the plug out an grease it there. Shouldn't be a big deal to install |
Author: | shooter [ Fri Aug 09, 2013 10:48 pm ] |
Post subject: | Re: Hidden Zerc Fitting on PD Lower Unit Tower? |
Figured. Thanks for the confirmation, gents. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |