HAHA!
I was told my DMM was built with Carlisle Panther sprockets and belt, I took the tail section off and found that it really had "dodge" sprockets, and an $11 belt.
| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Prop/gear ratio question https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=46732 |
Page 1 of 1 |
| Author: | wtyner86 [ Thu Oct 24, 2013 8:32 pm ] |
| Post subject: | Prop/gear ratio question |
I have an 18hp dixie running a 1.11:1 ratio, 36tooth:40tooth and an 11x10 prop. I had it on a light, riveted 1444 and it was running mid to high 20's, but i didn't have a tach and don't know how many RPM's I was running. I wore nearly 1/2" off the prop and switched to a lot heavier 1450, and now It's time for a new prop. My question is: Would I benefit more from a 10x8 or should I stick with the 11x10? |
|
| Author: | wtyner86 [ Thu Oct 24, 2013 8:52 pm ] |
| Post subject: | Re: Prop/gear ratio question |
What the hell? is there a difference in hillmarine.com and hillmarine.net? |
|
| Author: | wtyner86 [ Fri Oct 25, 2013 12:12 pm ] |
| Post subject: | Re: Prop/gear ratio question |
HAHA! I was told my DMM was built with Carlisle Panther sprockets and belt, I took the tail section off and found that it really had "dodge" sprockets, and an $11 belt.
|
|
| Author: | Will B Free [ Tue Nov 12, 2013 7:53 pm ] |
| Post subject: | Re: Prop/gear ratio question |
On a side note, hows your dixie holding up? You happy with the buy? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|