| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Beavertail problem https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=47433 |
Page 1 of 1 |
| Author: | Boudreaux76 [ Fri Nov 15, 2013 10:05 pm ] |
| Post subject: | Beavertail problem |
Need a hand here... Replacing shaft, seals, bearings, ujoint and lower bearing assembly housing cap. Problem is I can't for the life of me figure out how to get the 3 bearings out of my lower bearing assembly. I have gotten the top one out, but the bottom seems to be a bit elusive... Any ideas? The c clip is out and I have banged on table (on rubber mat), tried to wedge larger diameter rod and hammer it out with no luck... |
|
| Author: | Boudreaux76 [ Sat Nov 16, 2013 12:58 pm ] |
| Post subject: | Re: Beavertail problem |
Thanks for all the help... I went to car quest and rented a pilot bearing puller. Couple of taps with a mallet and I'm in business. |
|
| Author: | msm8281 [ Sat Nov 16, 2013 1:20 pm ] |
| Post subject: | Re: Beavertail problem |
Not many beavertail owners on here if any. Probably why u didn't get any help. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|