36 Gen 2 pd, Jamie b stg 2

Considering running a 27 3 blade and pitching up if need b to lower rpms. I'm guessing it will jump out the hole, might pick up a mph and prolly carry a load better. Thoughts/opinions?

Do it

Lol was hoping someone already did

Let us know how it runs I can do a little tweaking if u need

i know of a guy that did it... said he was getting 34mph with just heads..

i want to try it if I ever find a 3 blade... i hate to buy a new one to try

What's the specs on the 27 3 blade

Talked with Paul at Phowlers demo day about adding efi and heads to mine, and he said they've been doing it with a few motors and that they're picking up a little speed on the top end. Maybe he'll chime in with actual numbers

If you want phowler to do your heads n EFI youll pay 1000 bucks more than Pro Drive charges.

Sent from my SM-G900P using Tapatalk

Paul gave me a price on what I'm looking to have done and it certainly wasn't 1k more, was right in line with the list price pro-drive has on their website for the e2 kit...

That's better that the quote they gave me then...heads and intake for $1325?...no thanks.

Sent from my SM-G900P using Tapatalk

I'm gonna try it, just hate to buy a new one and keep paying to get it worked. Prop game sucks. I really wish I could just find a stumpgrinder prop

What are you running empty boat?

33 steady

Kinda hard to ask for more than that on a 1854 w/ 3/16th bottom and full welded floor. Are you turning 4700 rpm, and do you feel like you have much throttle left if you are on the rev limiter?

I think I can get a cpl hundred out of it

I have a 18x54 with center console and a 36 hp with the 3 blade it ran 26 mph at 4400 rpm
To the carb off and had pro-drive install the fuel injection now it runs 28 mph at 4500 to 4600
Installed the marshmellow muffler and did not notice any real noticeable gains but exhaust is helpfull but not enough to really make a noticeable difference unless it's tested on a dyno to actually see the gains

U have a gen 3?

Yes it's a gen 3 has the new latest gear reduction it's 2:1 I think the old was 1:5
It has the splined shaft 3 blade prop can't wait to try out the new 3 blade they are coming out with

Just tought I would share that information with you guys it's nice to see different configurations and compair them

Will do you know of some one that has tried this ? What was the out come if so ?

I saw some pretty crazy looking 3 blade cleavers on eBay the other day.

One of the rivers I been spending a lot of time on is nothing but shallow clean water with the occasional log. That splined shaft is the bomb for swapping props. I would love to get a prop that is good for nothing but speed.

Get a cheap old Evinrude prop and try it. Like a 3 blade 13.5" x 15p

Sounds la prop has the goods . Some one needs to fork over the dough.

Sent from my HTC One mini using Tapatalk

Subscribed.


Sent from my iPhone using Tapatalk

20140521_110820.jpgLike this

I'd have to try a regular outboard prop just to see, bet you can find one laying around a marine shop for little to nothing. Wouldn't matter if it's SS or aluminum just to try it for open water.

Well get to lookin'