MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
Gt 3 blade prop https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=54435 |
Page 1 of 1 |
Author: | MuddyWaterMallrds [ Mon Jun 30, 2014 8:29 am ] |
Post subject: | Gt 3 blade prop |
I got a Gtr35 with the new.3 blade prop, it runs decent I think, anybody like or dislike these? Any suggestions on getting more speed out of tgem? Got a few nicks in it from stumps and what not, how bad can it be till it looses Perfornance? Thanks |
Author: | OwenDickeson [ Mon Jun 30, 2014 8:34 am ] |
Post subject: | Re: Gt 3 blade prop |
From the few that I have run, they seem to be pretty good on the top end with some engine work, but they seem to rob alot of power on the bottom end, like its a little too much prop. |
Author: | doubleBanded [ Mon Jun 30, 2014 8:35 am ] |
Post subject: | Re: Gt 3 blade prop |
^what he said. I ran it for lil while n didn't like it I had a stock motor will try agian after stage two done |
Author: | MuddyWaterMallrds [ Mon Jun 30, 2014 8:44 am ] |
Post subject: | Re: Gt 3 blade prop |
Thanks guys, wgat about the nicks? |
Author: | doubleBanded [ Mon Jun 30, 2014 11:38 am ] |
Post subject: | Re: Gt 3 blade prop |
Wouldn't worry bout them unless they were big |
Author: | odass [ Mon Jun 30, 2014 12:54 pm ] |
Post subject: | Re: Gt 3 blade prop |
They Dam sure get a bite. Noticed that I have to trim way up from when I go from Rev. Or with the stock motor it will bog really bad. But empty my boat as big as it is was hitting 27. Not the best but it had me, 4 battery , light rails, generator, and ice chest. That as empty as I have ran it. Can't wait to get some mods |
Author: | BayouBuster [ Mon Jun 30, 2014 3:21 pm ] |
Post subject: | Re: Gt 3 blade prop |
In my opinion they are junk for running thick stuff and great for open water. That being said thin the blades up and you will see some gains. Of you thin it on the front side it will up the pitch a little, if you do the back it will take the pitch down. Just remember take too much and it will wear out twice as fast. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |