MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/
Any one know. https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=67155	Page 1 of 1

---

Author:	cj [ Fri Jun 10, 2016 6:28 pm ]
Post subject:	Any one know.
Any one know why you can't use the old style gt prop on the new style out drive. The gt boys say that is a no no. Anybody have any insight.

---

Author:	SCmudder7071 [ Fri Jun 10, 2016 6:43 pm ]
Post subject:	Re: Any one know.
I run one majority of the time. Haven't had any problems.

---

Author:	Frog [ Fri Jun 10, 2016 7:02 pm ]
Post subject:	Re: Any one know.
Too much vibration may crack your cast

---

Author:	TPerkins [ Sat Jun 11, 2016 7:45 am ]
Post subject:	Re: Any one know.
Ive seen numerous people running old powertech blades on tge new LU. I wasnt aware it was an issue. Sent from my SM-G920V using Tapatalk

---

Author:	rubbinisracin [ Sun Jun 12, 2016 5:58 pm ]
Post subject:	Re: Any one know.
I was told that it was all two blades because they are worried that if it threw a blade the vibration would be worse than a 3 blade that threw a blade. This seems kinda stupid considering the abundance of 2 blade mud motor props....they gotta know that we are gonna run 2 blade props...

---

Author:	SCmudder7071 [ Mon Jun 13, 2016 6:28 am ]
Post subject:	Re: Any one know.
A broken 3-blade will crack the lower just as quick as a 2-blade will.

---

Author:	rubbinisracin [ Mon Jun 13, 2016 7:38 am ]
Post subject:	Re: Any one know.
I tend to agree although technically it should be a little less magnitude of vibrational force from a failed 3 blade. I know now from running a 3 blade and a 2 blade that there are benefits to running the 2 blade and would be pretty dissapointed if I was forced to just run the 3 blade.

---

Author:	Quack N Stack [ Wed Jun 15, 2016 1:00 pm ]
Post subject:	Re: Any one know.

---

Page 1 of 1	All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/