hey guys i was greasing the shaft of my LT and the grease nipple popped out when i tried to pull the grease gun off. It is the one under the high vis grease thing bout half way up the shaft. Can i just hammer it back in or what?

If i'm not mistaken they are threaded into the shaft housing. I'm thinking hammering it back in is a bad idea. But I'd check with some else before I did anything. I'm no expert on longtails!

yes its threaded, no dont hammer it in. bring the old one to NAPA and they can match it up.

Oh my god, a go-devil did what? break? where the phuck is giga? they shouldn't put grease fittings on those, they're unreliable....they need to be more like scavenger with no fittings....holy phuck it's just a lawnmower engine....dammit.