ok this may sound like a stupid question but is it hard to start a go-devil engine with the prop in the water? and btw my engine is only pull start
so how hard would it be?
| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| starting go-devil https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=13550 |
Page 1 of 1 |
| Author: | go-devil15 [ Thu Nov 04, 2010 7:59 pm ] |
| Post subject: | starting go-devil |
ok this may sound like a stupid question but is it hard to start a go-devil engine with the prop in the water? and btw my engine is only pull start so how hard would it be?
|
|
| Author: | mud man [ Thu Nov 04, 2010 8:09 pm ] |
| Post subject: | Re: starting go-devil |
Just get ready to move when it starts. Remember when you pull the cord your not just turning the motor over your spining the prop in the water as well. Hope it's not a stupid answer:-) |
|
| Author: | go-devil15 [ Thu Nov 04, 2010 8:42 pm ] |
| Post subject: | Re: starting go-devil |
lol yup i knew that was gunna happen, i just think it will be hard to start it by holding it out the water and pull starting it and im onlyin a 14x38 boat so not a whole lotta space lol |
|
| Author: | kibb [ Thu Nov 04, 2010 8:55 pm ] |
| Post subject: | Re: starting go-devil |
Tie a rope in your boat with a loop that slides over the handle to hold the handle down and prop out of the water. |
|
| Author: | go-devil15 [ Thu Nov 04, 2010 8:56 pm ] |
| Post subject: | Re: starting go-devil |
yup i can do that............i think all this nutria meat ive been eating has gotten to me
|
|
| Author: | Robn1020 [ Fri Nov 05, 2010 6:36 am ] |
| Post subject: | Re: starting go-devil |
You're go-devil should have a mercury switch. Its a 1 inch tube like object. Though i don't recomend moving it, you can reposition it to start the motor in the water. |
|
| Author: | Joe-Nathan [ Fri Nov 05, 2010 6:49 am ] |
| Post subject: | Re: starting go-devil |
When I have to use the pull chord, I usually tilt motor up so that I can stand on the tiller handle. This way you can use the tiller a leverage. Usually starts with on pull. |
|
| Author: | go-devil15 [ Fri Nov 05, 2010 9:56 pm ] |
| Post subject: | Re: starting go-devil |
what do you mean by mercury switch? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|