Well I finally got my GO Devil running without having to pump the primer! Had to replace the fitting on the tank, cause it was too loose replace the fuel line and bulb too. took it out the same day and it ran amazing! I took it up the river and then went out to the harbour. Every person I went by either stared, doubletaked, took pictures or all 3. Not many mud boats round here i guess lol! Now that I actually had it running for more then an hour I wanna grease the shaft. bought a gun but am a little confused as where to grease it. Read the manual and it said only grease the shaft. but where do i do it on the little nipple or the piece below the nipple with the little nut on it. I'd call Go Devil but I work while they are open. Any and all info greatly appreciated!

pick of what your looking at ?

the screw with the nut on it is just to keep the middle bushing from moving. grease the shaft only at the fitting, not on the lubricator, until you see the plunger in the lubricator go up. thats it.

And keep both eyes on the prop