MudmotorTalk.com
https://www.mudmotortalk.com/mmt_v2/

mmt nu b long tail build questions
https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=21706
Page 1 of 1

Author:  outdoor freak [ Fri Sep 02, 2011 10:33 pm ]
Post subject:  mmt nu b long tail build questions

im building a long tail i have everything to do so bu t have a few questions and it would be awesome for some info

are the mud buddy ,go devil ,backwater props all interchangable and what thread im using 3/4 rod

what size prop should i put on it i have a very light 1448 modified v boat and the motor is a briggs twin 12.5 with the cast iron sleeve one of the good old motors, dual exhaust and carb work

Author:  Woodiebuster [ Fri Sep 02, 2011 10:40 pm ]
Post subject:  Re: mmt nu b long tail build questions

The industry standard is 3/4" 10tpi shaft. all of them will fit

9x3.

Author:  outdoor freak [ Fri Sep 02, 2011 10:59 pm ]
Post subject:  Re: mmt nu b long tail build questions

another question is how do i set the angle on my cav plate should it lay flat across the water or be angled up in the back a little ?

Author:  garjacker [ Sat Sep 03, 2011 7:28 pm ]
Post subject:  Re: mmt nu b long tail build questions

mine set parralel with the motor mount plate. i have a 9 and 16hp.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/