I had one on a boat years back. It is nice but weld dat mother in your boat. The rivnuts pull out da floor!
| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Any one have any experience with the godevil handle bar kit. https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=22117 |
Page 1 of 1 |
| Author: | CD1975 [ Wed Sep 14, 2011 8:49 pm ] |
| Post subject: | Any one have any experience with the godevil handle bar kit. |
I just got one in the mail and it seems straightnforward on assembly. I am worried about rivnut ing it to the floor in my grizzly 1448. Does any one think this may be a bad idea? Let me know if you have any experience with it bad or good. thanks |
|
| Author: | Quack Stackin [ Wed Sep 14, 2011 8:52 pm ] |
| Post subject: | Re: Any one have any experience with the godevil handle bar |
Just a ? But where did you order it from? I never saw on their site where to order just that it was an option on their boats |
|
| Author: | CD1975 [ Wed Sep 14, 2011 9:10 pm ] |
| Post subject: | Re: Any one have any experience with the godevil handle bar |
No if you call them up they where more then happy to send me one .as well as the grease cup and new bushing seals the whole bit. It has a universal set up so I think it will work well with the flat bottom on my gizzyl 1448. The set came with extra rivet nuts and all. I will let u all know how it works after I gettr bolted down and use it in some real world simulation. Good fun and good hunting. CD |
|
| Author: | CD1975 [ Wed Sep 14, 2011 9:16 pm ] |
| Post subject: | Re: Any one have any experience with the godevil handle bar |
| Author: | mcnemar1982 [ Wed Sep 14, 2011 10:35 pm ] |
| Post subject: | Re: Any one have any experience with the godevil handle bar |
I had one on a boat years back. It is nice but weld dat mother in your boat. The rivnuts pull out da floor!
|
|
| Author: | daddyflea [ Sun Sep 18, 2011 9:28 am ] |
| Post subject: | Re: Any one have any experience with the godevil handle bar |
These things are supposed to go on your Cross braces and I put mine on my self. Not too bad but don't trust the instructions. My instructions called for a bigger drilled hole than it should have had. Drill just big enough Hole to get it through. So far mine has been good mounted on a Alumacraft Boat. I hit a completely submerged stump yesterday that was out where I thought I could run wide open. It held and I am thankful. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|