| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Homemade longtial?- U-joint https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=24193 |
Page 1 of 1 |
| Author: | TBK [ Sat Nov 19, 2011 9:15 pm ] |
| Post subject: | Homemade longtial?- U-joint |
Building a longtail and need help with the u-joint. My motor shaft is 5/8 and my drive shaft is ¾. Both have 3/16 keyways. Transom is 16 inches and drive shaft is 72”. I’ve been trying to research u-joints on other builds but I can’t figure this last part out. Can someone give me advice on a part or model number? Thanks for the help. |
|
| Author: | carmes001 [ Sat Nov 19, 2011 9:53 pm ] |
| Post subject: | Re: Homemade longtial?- U-joint |
mcmaster.com |
|
| Author: | garjacker [ Sun Nov 20, 2011 11:03 am ] |
| Post subject: | Re: Homemade longtial?- U-joint |
I think you are needing the yoke sizes. Napa and tractor supply also carry these. you can mix the shaft diameter sizes as long as they accept the same size u-joint. |
|
| Author: | bayouboy [ Sun Nov 20, 2011 11:29 am ] |
| Post subject: | Re: Homemade longtial?- U-joint |
| Author: | TBK [ Sun Nov 20, 2011 9:29 pm ] |
| Post subject: | Re: Homemade longtial?- U-joint |
Sweet, thanks guys. |
|
| Author: | ironman_gq [ Tue Nov 22, 2011 1:53 pm ] |
| Post subject: | Re: Homemade longtial?- U-joint |
http://www.driveshaftparts.com/ They have a mix and match set, you pick your shaft sizes and they sell you both yokes and a joint for $25 |
|
| Author: | ironman_gq [ Tue Nov 22, 2011 1:54 pm ] |
| Post subject: | Re: Homemade longtial?- U-joint |
FYI, you need the 1000 series kit on the front page |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|