| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| 27 beavertail longtail lower bearing/seal https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=24585 |
Page 1 of 1 |
| Author: | dwhipper61 [ Sat Dec 03, 2011 12:17 pm ] |
| Post subject: | 27 beavertail longtail lower bearing/seal |
Hello, I have a 27hp Beavertail longtail 2009 model. I ran it last week and then shot 2-3 pumps of grease into the zink in the middle of the shaft. After running if today I noticed a very small about of grease between the seal and shaft. Did I blow out the seal? Is a small amount of grease OK, or do I need to replace the bearing/seal? THANKS |
|
| Author: | Crewcab [ Sat Dec 03, 2011 8:57 pm ] |
| Post subject: | 27 beavertail longtail lower bearing/seal |
I think your ok. I would replace it after the season. The fishers told me once that in that middle zerk one our 2 plumps a season and that is it. |
|
| Author: | dwhipper61 [ Mon Dec 05, 2011 6:21 pm ] |
| Post subject: | Re: 27 beavertail longtail lower bearing/seal |
I took the middle zirk out and some nice clean grease pushed out of the hole. Ran the motor for a few hours after and checked for a leaking seal. It looked OK, but I had A LOT of vegetation twisted around the bearing, so could not get a good test. THANKS for any and all comments. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|