MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
Shaft Size? https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=26417 |
Page 1 of 1 |
Author: | steveamato [ Sun Feb 05, 2012 4:11 pm ] |
Post subject: | Shaft Size? |
Thinking about building a motor for my 16 foot Blind boat. This will just be used to get into a few shallow marshes. The majority of the time I use my outboard. I was thinking of buying the Mad Mud Motor plans and probalby building something like a 16 hp motor. Probalby the 420cc Predator engine. I know this is probably small on the HP, but speed will not be a factor. For the amount of time used, cost is an issue. My question is I have already found a 65inch Cold Roll Steel 3/4 inch shaft for no cost. Boat is a short transom. It seems like most shafts are 72 inches. Would this 65inch shaft work? Thanks |
Author: | Randal [ Sun Feb 05, 2012 6:26 pm ] |
Post subject: | Re: Shaft Size? |
65" is short, but I bet you could make it work. I am working on a 7 HP with about a 60" shaft but I dont have it going yet, but it looks like it will do just fine. |
Author: | steveamato [ Sun Feb 05, 2012 9:33 pm ] |
Post subject: | Re: Shaft Size? |
Do I need the extra 7 inches for enought bite in the water or what? |
Author: | Buzz Killington [ Sun Feb 05, 2012 9:35 pm ] |
Post subject: | Shaft Size? |
What's the transom height? I run a 20hp - 65" and it runs excellent My 9hp is on a 72 lol Bow your cavitation plate - got the idea from Backwater - works like a charm |
Author: | steveamato [ Mon Feb 06, 2012 9:04 am ] |
Post subject: | Re: Shaft Size? |
My transom is a 16inch. What is backwater? Is it a website? |
Author: | steveamato [ Mon Feb 06, 2012 9:05 am ] |
Post subject: | Re: Shaft Size? |
Actually I have no idea what a shaft costs, so maybe I will just buy a new one. I just happen to already have this shaft for free. |
Author: | Buzz Killington [ Mon Feb 06, 2012 1:21 pm ] |
Post subject: | Re: Shaft Size? |
Author: | TimberGHOST [ Mon Feb 06, 2012 7:36 pm ] |
Post subject: | Re: Shaft Size? |
im running a 56" shaft with a 15hp lifan that does great! if u do wanna buy a new shaft to to stockcarsteel.com they are outta one of the carolinas but they are CHEAP and FAST they do all kinds of shafts and dom tubing plus flat, sheet, and welded tubing too. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |