MudmotorTalk.com
https://www.mudmotortalk.com/mmt_v2/

tall transom
https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=27850		 Page 1 of 1
Author:  m86bronco [ Thu Mar 22, 2012 8:42 am ]
Post subject:  tall transom
what can you do to a 27 gdlt to help it perform better on a tall transom boat 21"
Author:  BoatDR [ Thu Mar 22, 2012 8:50 am ]
Post subject:  Re: tall transom
Cut the transom down to 16".
Author:  m86bronco [ Thu Mar 22, 2012 8:54 am ]
Post subject:  Re: tall transom
i really would rather not to cut it cause it has been re braced and i run a outboard on it too
Author:  WAD SHOOTER [ Thu Mar 22, 2012 9:02 am ]
Post subject:  Re: tall transom
You could always cut it down then add a jackplate for the outboard. Lower the jackplate for the mud motor, then raise it for the outboard.
Author:  m86bronco [ Thu Mar 22, 2012 9:06 am ]
Post subject:  Re: tall transom
could i use jack plate for mud motor now?
Author:  WAD SHOOTER [ Thu Mar 22, 2012 9:11 am ]
Post subject:  Re: tall transom
Author:  m86bronco [ Thu Mar 22, 2012 9:13 am ]
Post subject:  Re: tall transom
well that gives me some options. i have heard of lt being set up for tall transoms i didnt know how people did it or if there are kits to buy
Author:  XGEN-DUCKMAN [ Thu Mar 22, 2012 8:34 pm ]
Post subject:  Re: tall transom
The tall transom motors have longer shafts......
Author:  duck [ Fri Mar 23, 2012 5:06 am ]
Post subject:  Re: tall transom
First you need to find out if your motor is for a short transom or tall transom. my longtail was made for a tall transom and works good on my tall transom boat.
Author:  m86bronco [ Fri Mar 23, 2012 5:15 am ]
Post subject:  Re: tall transom
It had a 72 in shaft
Author:  indawoods [ Sat Mar 31, 2012 1:04 am ]
Post subject:  Re: tall transom
Author:  Buzz Killington [ Sat Mar 31, 2012 6:30 am ]
Post subject:  tall transom
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/