| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| need help finding parts https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=29281 |
Page 1 of 1 |
| Author: | littlegarlic [ Thu May 17, 2012 3:37 pm ] |
| Post subject: | need help finding parts |
I bought a homemade mud motor a couple of years ago and it looks like the bronze bushings finally went out. I can see all the scouring from sand a other stuff, and I know the motor is based off of a go-devil. The problem I'm having is that I can't find any shoulder style bushings with such a large flange section. I've attached a picture showing the only two that were at the top and bottom of the shaft as well as the end caps. I do have access to a lathe if i need to make them myself |
|
| Author: | Rendon_6 [ Thu May 17, 2012 3:58 pm ] |
| Post subject: | Re: need help finding parts |
check with mcmaster, msc, granger, motion indrustrial and theres a few more. Whats the ID and OD and lenght of the parts and ill look and see what i can find. |
|
| Author: | littlegarlic [ Fri May 18, 2012 9:42 am ] |
| Post subject: | Re: need help finding parts |
I.D. 3/4" O.D. 1" flange dimensions 1.120" O.D. X 0.640 wide overall length = 2.102 There is a motion industries nearby, I'll probably stop by there with the parts and see what they can do. I was also thinking about the possibility of changing out the end caps to allow for a smaller shoulder type bushing. Also, since I have the shaft completely taken apart I was thinking about switching grease types from the regular lithium to the red lithium grease? |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|