MudmotorTalk.com
https://www.mudmotortalk.com/mmt_v2/

Longtail slop in pivot bracket????
https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=29948
Page 1 of 1

Author:  ginger-suzzy [ Thu Jun 14, 2012 5:09 am ]
Post subject:  Longtail slop in pivot bracket????

I have a 31 hp godevil and there is a lot of slop right there where that top swivel and the bottom transom clamp meet. There is that rubber gasket in between there with that big bolt that holds all of that together. any ideas would be helpful.

Author:  SwampSlut [ Thu Jun 14, 2012 5:40 am ]
Post subject:  Re: Longtail slop in pivot bracket????


Author:  ginger-suzzy [ Fri Jun 15, 2012 11:36 am ]
Post subject:  Re: Longtail slop in pivot bracket????

There is no way that bolt will tighten at all that joker is tight as he##!!

Author:  SwampSlut [ Fri Jun 15, 2012 12:35 pm ]
Post subject:  Re: Longtail slop in pivot bracket????


Author:  autogateman [ Fri Jun 15, 2012 12:48 pm ]
Post subject:  Longtail slop in pivot bracket????

Get new bushings. They're cheap.

Author:  garjacker [ Sat Jun 16, 2012 6:18 am ]
Post subject:  Re: Longtail slop in pivot bracket????

its just a 3/4 inch thrust washer. the're bronze. thats what they run on, the rubber is just to hold grease in. go to an ace or or other parts store and get you one.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/