| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Vertical https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=30578 |
Page 1 of 1 |
| Author: | wing [ Sat Jul 07, 2012 3:53 pm ] |
| Post subject: | Vertical |
I have a LT mud buddy chassy it had a 27 kawasaki on it. I want to repower it cheap i can't find a horizontal for cheap i am running a 16 ft fisher. Verticals are cheap and everywhere has anyone repowered with a vertical. |
|
| Author: | benellibrian [ Sat Jul 07, 2012 4:32 pm ] |
| Post subject: | Re: Vertical |
How do you even plan on running a vertical shaft motor on a LT??? |
|
| Author: | wing [ Sat Jul 07, 2012 4:42 pm ] |
| Post subject: | Re: Vertical |
With another set of u joint with a bearing |
|
| Author: | benellibrian [ Sat Jul 07, 2012 4:49 pm ] |
| Post subject: | Re: Vertical |
Sounds like loss of power and a pain in the ass. With out looking at one I would think the ujoint would have to be at a 90 . I'd say dont waste your time get a horizontal and be done. |
|
| Author: | wing [ Sat Jul 07, 2012 7:52 pm ] |
| Post subject: | Re: Vertical |
I would be using 4 u joint not two at a 90 i was thinking it would be a loss of power I have a old 15 briggs on it now but i only go about 5 mph i guy i know has a 22 vert. Do you think i could get more out of a new 16 durmax than the old 1969 15hp briggs. i would like 12 to 15 mph |
|
| Author: | wing [ Sat Jul 07, 2012 7:54 pm ] |
| Post subject: | Re: Vertical |
thanks for you info |
|
| Author: | Buzz Killington [ Sun Jul 08, 2012 6:53 am ] |
| Post subject: | Vertical |
Horizontal for LT Vertical for ProDrive You'd lose a lot of power running 4 u joints Just a bad idea IMO. |
|
| Author: | wing [ Sun Jul 08, 2012 12:05 pm ] |
| Post subject: | Re: Vertical |
Thanks again Any idea about my old 15 briggs to a new 16 dumax |
|
| Author: | wing [ Sun Jul 08, 2012 12:06 pm ] |
| Post subject: | Re: Vertical |
Thanks again Any idea about my old 15 briggs to a new 16 dumax |
|
| Author: | Woodiebuster [ Sun Jul 08, 2012 8:09 pm ] |
| Post subject: | Re: Vertical |
Do it right the first time and get a horizontal. |
|
| Author: | wm [ Sun Jul 08, 2012 8:30 pm ] |
| Post subject: | Re: Vertical |
| Author: | Woodiebuster [ Sun Jul 08, 2012 10:07 pm ] |
| Post subject: | Re: Vertical |
35 briggs but of the two, a 23 |
|
| Author: | Buzz Killington [ Mon Jul 09, 2012 5:03 am ] |
| Post subject: | Vertical |
X2 on the 23 |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|