| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| new seal for my gd https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=4572 |
Page 1 of 1 |
| Author: | quackhead [ Sun Sep 13, 2009 5:57 pm ] |
| Post subject: | new seal for my gd |
I have a 25hp gd it has the old seal system on and its bad does anyone know were i can get a new seal system for it all i need is the bottom. |
|
| Author: | Tenpoint [ Sun Sep 13, 2009 6:02 pm ] |
| Post subject: | Re: new seal for my gd |
Any Go-Devil dealership should carry the parts. I had my old GD seals replaced and had the new style upper bearing installed on the shaft tube at the local GD dealer. |
|
| Author: | quackhead [ Sun Sep 13, 2009 6:51 pm ] |
| Post subject: | Re: new seal for my gd |
| Author: | Tenpoint [ Mon Sep 14, 2009 4:26 pm ] |
| Post subject: | Re: new seal for my gd |
Its been a while, I really dont remember Id have to find the receipt. I had alot done at one time. I had a new shaft, u-joint, upper bearing assembly, and lower bushing and seals and all that ran me about $160. |
|
| Author: | quackhead [ Mon Sep 14, 2009 4:36 pm ] |
| Post subject: | Re: new seal for my gd |
ok thanks all i need is a new bushing and seal |
|
| Author: | quackhead [ Mon Sep 14, 2009 4:36 pm ] |
| Post subject: | Re: new seal for my gd |
ok thanks all i need is a new bushing and seal |
|
| Author: | backwaterballer [ Mon Sep 14, 2009 5:16 pm ] |
| Post subject: | Re: new seal for my gd |
I put the new style in mine a couple months back just the bottom end had to get the two seals and the new style cap it was only like 35 buck and easy two replace except gettin the prop off. |
|
| Author: | quackhead [ Mon Sep 14, 2009 5:22 pm ] |
| Post subject: | Re: new seal for my gd |
were did i get it from? thnx |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|