| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Overheating bearing and chattering noise https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=47897 |
Page 1 of 1 |
| Author: | rob_rides_03 [ Mon Dec 02, 2013 4:30 pm ] |
| Post subject: | Overheating bearing and chattering noise |
Recently noticed a chattering noise coming from my 27 longtail. The collar seems to get hot and the grease is dripping from the bearing. Also having a problem keeping the set screws in the lower part of u-joint tight. Put a new prop on the motor 2 weeks ago. Is this an alignment issue with the shaft or would that upper bearing be shot? There is no slack in the u-joint either. Shaft has a slight wobble to it but is an 85" drive so I think that would be expected. I put the new shaft in a year ago and it had a wobble to it then too. Lower collar is fine. Doesn't get hot and has no grease coming out of it. Thanks |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|