| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| home build https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=52458 |
Page 1 of 1 |
| Author: | HR2labs [ Thu Apr 17, 2014 8:11 pm ] |
| Post subject: | home build |
ok I forget the shaft is 72 inches long 3/4 round know the outside housing should be what length is it 60 inches also do I need to adjust the overall length for the length of the two bearing housing thanks |
|
| Author: | coupe1975 [ Thu Apr 17, 2014 9:01 pm ] |
| Post subject: | Re: home build |
Not sure but I'll put a measuring tape and check in the morning for you |
|
| Author: | SwampDonkey1 [ Thu Apr 17, 2014 11:55 pm ] |
| Post subject: | Re: home build |
shouldnt matter, just as long as you leave enough space for the essentials... prop to thread on one end and a yoke on the other... |
|
| Author: | mud slinger 69 [ Fri Apr 18, 2014 5:45 am ] |
| Post subject: | Re: home build |
^^ this |
|
| Author: | HR2labs [ Sat Apr 19, 2014 5:21 am ] |
| Post subject: | Re: home build |
What's this mean all I c in your response is a upside down v |
|
| Author: | mud slinger 69 [ Sat Apr 19, 2014 5:31 am ] |
| Post subject: | Re: home build |
Pointing up to the last post. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|