| MudmotorTalk.com https://www.mudmotortalk.com/mmt_v2/ |
|
| Motor swap https://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=63081 |
Page 1 of 1 |
| Author: | Brian stichter [ Thu Aug 06, 2015 11:39 am ] |
| Post subject: | Motor swap |
Motor swap question Can I replace a 27 Kohler with a 35 Briggs on beaver tail . Are the frames and prop the same Thanks |
|
| Author: | FRANKtheTAU [ Thu Aug 06, 2015 12:35 pm ] |
| Post subject: | Re: Motor swap |
No sir. Different mounting plate, different crankshaft height, and different prop. |
|
| Author: | Brian stichter [ Thu Aug 06, 2015 1:49 pm ] |
| Post subject: | Re: Motor swap |
thanks Frank |
|
| Author: | cb5331 [ Thu Aug 06, 2015 2:07 pm ] |
| Post subject: | Re: Motor swap |
Shaft height is the same, and I believe the mounting holes are the same also.. |
|
| Author: | FRANKtheTAU [ Thu Aug 06, 2015 6:41 pm ] |
| Post subject: | Re: Motor swap |
My apologies! I misspoke. I had just been talking with a local guy a about swapping a blown 23 Briggs for a new Predator v twin. I guess my brain defaulted to the 23 instead of actually paying attention and reading 27 Kohler. I believe shaft height ist he same but not 100% on the mounting plate. |
|
| Author: | Brian stichter [ Thu Aug 06, 2015 8:29 pm ] |
| Post subject: | Re: Motor swap |
Thanks for the input |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|